Garage Door Spring Repair

A garage door spring carries almost the entire weight of the door. When one breaks, the opener is suddenly lifting a load it was never built for. San Marcos Garage Door Repairs inspects the spring system, cables and bearings before fitting anything new.

  • 24/7 Service
  • Upfront Quotes
  • All Major Brands

Signs That Need Attention

  • A loud bang from the garage, then a door that will not lift
  • A clear gap in one of the coils on the shaft above the opening
  • The opener straining, humming, or stopping a few inches up
  • The door feeling extremely heavy if you try to raise it by hand
  • A door that drops fast instead of lowering steadily

Springs are rated to the weight and travel of one particular door, so a replacement has to match the door in your garage rather than the one next door. On the newer streets around San Marcos, whole blocks were fitted with the same door in the same season, which is why neighbors often need spring work within a year or two of each other.

Two-story house with a wide dark sectional garage door

What the Service Includes

Not every visit needs every item below. San Marcos Garage Door Repairs separates the repair that fixes today's failure from work you may want to plan for later, and says which is which.

Matched replacement springs

Door weight, height and the lift arrangement decide the correct spring. Two coils that look alike can be rated very differently, and the wrong one wears out quickly.

Cables, drums and bearings checked

A spring rarely fails in isolation. Center bearings, end plates, drums and lift cables are inspected while the shaft is accessible and the door is secured.

Balance and safety test

Once the springs are set, the door is tested for balance through its full travel and the opener's reversing and sensor functions are checked before the visit ends.

Your Repair Options

The quote should name the failed parts, the compatible replacements and any related work the inspection turned up. If a cable has also come off a drum or a bearing has seized, that appears on the same estimate rather than surfacing later.

Where a cable or roller is involved, see cable and roller repair. If the opener has been straining against an unbalanced door for months, opener repair may belong in the same visit. When a door has needed several repairs in a short stretch, our repair versus replacement guide sets out what usually decides it.

Spring work is carried out across the area, including Kyle. Check the full service area list if your town is not shown.

Spring Repair Questions

What decides the cost of a spring repair?

The door and its hardware do. A single spring on a light single-bay door is a different job from a pair on a heavy insulated double, and a seized bearing or damaged cable adds parts. San Marcos Garage Door Repairs inspects first and quotes before the work starts.

Should both springs be replaced at the same time?

Usually yes, on a two-spring door. Both springs have taken the same number of cycles, so replacing one often means a second call not long after. The technician will explain what the inspection shows for your door.

How long does a spring replacement take?

Most straightforward spring jobs are finished in one visit. If the door turns out to need an unusual size or the shaft and bearings are worn, parts may have to be ordered and the timeline is explained on site.

What should I do while I wait?

Leave the door closed, keep the opener unplugged and keep people and vehicles out from under it. Do not pull the emergency release while the door is raised. See how the visit works for what happens next.

Arrange garage door service in San Marcos

Heard a bang and now the door will not move? Leave it closed and call it in.

Call Now Request Service